1. Control system: There is a control box on the ground, which is equipped with left, right, jog, stop buttons, and corresponding indicator lights. All electrical components in the control box are made of domestic products.
2. Rust removal and coating requirements
The rust removal on the surface of steel plates, profiles, and castings and forgings shall reach level ST2 in GB8923. The thickness of the paint film is 90-120um. Rust prevention treatment shall be carried out on all exposed machined surfaces before leaving the factory. The surface is coated with anti rust primer and dark gray topcoat, while the guide rail is not painted.
3. Control box system: The control box is made of steel plate, beautiful and practical, with anti-corrosion treatment on the surface. The thickness of the box body plate is not less than 2 millimeters, and it has a good heat dissipation device. There are practical maintenance lights inside the control box. The door lock is firm and reliable, easy to use, and does not interfere.
4. Equipment configuration: Various industrial components should be selected to provide sufficient guarantee for the overall reliability of the equipment.
5. Equipment structure: The turntable car consists of a frame, a rotating platform, a driving device, a control box, etc. The rotating table body is equipped with guide rails, and the rotating table is composed of a rotating configuration and a worktable produced by introducing advanced German patented technology, which can rotate 90 degrees. It has the characteristics of flexible rotation, rapid response, and safe and reliable performance. The track docking is achieved through automatic deceleration control using a frequency converter, and an electrically controlled safety limit device is installed between the 90o positions to ensure accurate positioning of the rotating table during rotation, ensuring good alignment between the main guide rail and the ground track; There is an auxiliary support wheel set under the rotating table to ensure the safety and stability of the rotating tables load-bearing capacity.
6. Frame system: The frame adopts a plate frame structure, consisting of longitudinal beams, transverse beams, and steel plates forming a "#" - shaped skeleton plate frame structure, with steel plates laid on the workbench. The profiles and steel plates used comply with the corresponding national standards.
7. Transmission system: The electric motor drives the reducer, transmitting power to the rotary device and driving the rotating table to rotate. Each component is reliably connected to the main body. The motor adopts a brake motor with a protection level of IP44 and an insulation level of E.